Free Shipping

on orders over Rs 5000. This offer is valid on all our store items.
Cart (empty)
Your cart is empty
MENU

Interfacing and Driver ICs

  • FT232RL - USB to Serial UART interface
    FT232RL - USB to Serial UART interface
    TPS-00124        FT232RL USB to serial UART interface             Single chip USB to asynchronous serial data transfer interface. Entire USB protocol handled on the chip - No USB-specific firmware programming required. UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity. Fully assisted hardware or X-On / X-Off software handshaking. Data transfer rates... TPS-00124        FT232RL USB to serial UART ...
    Rs.220.00
    More
     Sold Out 
  • FT245RL - USB to Parallel FIFO Interface
    FT245RL - USB to Parallel FIFO Interface
    TPS-00777        FT245RL USB FIFO interface Integrated Circuit Device features Single chip USB to parallel FIFO bidirectional data transfer interface. Entire USB protocol handled on the chip - No USB-specific firmware programming required. Simple interface to MCU / PLD / FPGA logic with simple 4-wire handshake interface. Data transfer rate to 1 Megabyte / second - D2XX Direct Drivers. Data transfer rate to 300 kilobyte / second - VCP Drivers. FTDI’s... TPS-00777        FT245RL USB FIFO interface ...
  • Heatsink for 15-lead Multiwatt Package Components (L298)
    Heatsink for 15-lead Multiwatt Package Components (L298)
    Heatsink for 15-lead Multiwatt Package Components (For L298) Heatsink for 15-lead Multiwatt Package Components (For L298)...
  • L293D - H-Bridge Motor Driver
    L293D - H-Bridge Motor Driver
    TPS-00125        L293D QUADRUPLE HALF-H DRIVERS Feature Wide Supply-Voltage Range: 4.5 V to 36 V Separate Input-Logic Supply Internal ESD Protection Thermal Shutdown High-Noise-Immunity Inputs Output Current 600 mA Per Channel Output Clamp Diodes for Inductive Transient Suppression (L293D) Package Type - 16 Pin DIP TPS-00125        L293D QUADRUPLE HALF-H DRIV...
  • L297 - Stepper Motor Controller
    L297 - Stepper Motor Controller
    TPS-01164        L297   STEPPER MOTOR CONTROLLERS NORMAL/WAVE DRIVE HALF/FULL STEP MODES CLOCKWISE/ANTICLOCKWISE DIRECTION SWITCHMODE LOAD CURRENT REGULATION PROGRAMMABLE LOAD CURRENT FEW EXTERNAL COMPONENTS RESET INPUT & HOME OUTPUT ENABLE INPUT   Package Type - 20 Pin DIP TPS-01164        L297   STEPPER MOTOR C...
  • L298N - H-Bridge Motor Driver
    L298N - H-Bridge Motor Driver
    TPS-00126        L298 Dual Full Bridge Driver Features OPERATING SUPPLY VOLTAGE UP TO 46V TOTAL DC CURRENT UP TO 4A LOW SATURATION VOLTAGE OVERTEMPERATURE PROTECTION LOGICAL "0" INPUT VOLTAGE UP TO 1.5 V (HIGH NOISE IMMUNITY)      Package Type   Multiwatt15 V TPS-00126        L298 Dual Full Bridge Drive...
  • LM3914 - Dot/Bar Display Driver
    LM3914 - Dot/Bar Display Driver
    TPS-00127        LM3914 LM3914 Dot/Bar Display Driver Features Drives LEDs, LCDs or Vacuum Fluorescents Bar or Dot Display Mode Externally Selectable by User Expandable to Displays of 100 Steps Internal Voltage Reference from 1.2V to 12V Operates with Single Supply of Less than 3V   Package Type - 18 Pin DIP TPS-00127        LM3914 LM3914 Dot/Bar Displ...
  • MAX232 - Dual Driver/Receiver
    MAX232 - Dual Driver/Receiver
    TPS-00129        MAX232 MAX232x Dual EIA-232 Drivers/Receivers Features Operates from a Single 5-V Power Supply With 1.0-µF Charge-Pump Capacitors Operates up to 120kbits Two Drivers and Two Receivers +-30V Input Levels Low supply current 8mA Typical   Package Type - 16 Pin DIP   TPS-00129        MAX232 MAX232x Dual EIA-232...
  • MAX232 - SMD Package Dual Driver/Receiver
    MAX232 - SMD Package Dual Driver/Receiver
    TPS-00130        MAX232-SMD MAX232x Dual EIA-232 Drivers/Receivers   Operates from a Single 5-V Power Supply With 1.0-µF Charge-Pump Capacitors Operates up to 120kbits Two Drivers and Two Receivers +-30V Input Levels Low supply current 8mA Typical   Package Type – SOP 16 (10.3mmX6mm)   TPS-00130        MAX232-SMD MAX232x Dual EIA...
  • MAX3232 ,3.0V - 5.5V 1Mbps,RS-232 Transceivers -SMD
    MAX3232 ,3.0V - 5.5V 1Mbps,RS-232 Transceivers -SMD
    TPS-00792        MAX3232   MAX3232 3-V to 5.5-V Multichannel RS-232 Line Driver/Receiver with ±15-Kv ESD Protection Features Operates with 3v to 5.5v vcc supply Operates upto 250kbits/s Two drivers and two receivers Low supply current 300uA typical Accepts 5v logic input with 3.3v supply   Package Type - 16 Pin SOIC (10.3mmX7.5mm)   MAX3232ESE ,3.0V - 5.5V 1Mbps,RS-232 Transceivers - SMD Package Download MAX3232ESE datasheet TPS-00792        MAX3232   MAX3232 3-V ...
  • MAX485 - RS-485/RS-422 Transceiver
    MAX485 - RS-485/RS-422 Transceiver
    TPS-00128        MAX485   Low-power transceivers for RS-485 and RS-422 communication Next Generation Device Features For Fault-Tolerant Applications MAX3430: ±80V Fault-Protected, Fail-Safe, 1/4 Unit Load, +3.3V, RS-485 Transceiver MAX3440E–MAX3444E: ±15kV ESD-Protected, ±60V Fault-Protected, 10Mbps, Fail-Safe, RS-485/J1708 Transceivers For Space-Constrained Applications MAX3460–MAX3464: +5V, Fail-Safe, 20Mbps, PROFIBUS... TPS-00128        MAX485   Low-power tra...
  • MAX487 - RS-485/RS-422 Transceiver -128 bus
    MAX487 - RS-485/RS-422 Transceiver -128 bus
    TPS-01103        MAX487 Low-power transceivers for RS-485 and RS-422 communication Features For Fault-Tolerant Applications MAX3430: ±80V Fault-Protected, Fail-Safe, 1/4 Unit Load, +3.3V, RS-485 Transceiver MAX3440E–MAX3444E: ±15kV ESD-Protected, ±60V Fault-Protected, 10Mbps, Fail-Safe, RS-485/J1708 Transceivers For Space-Constrained Applications MAX3460–MAX3464: +5V, Fail-Safe, 20Mbps, PROFIBUS RS-485/RS-422 Transceivers... TPS-01103        MAX487 Low-power transceive...